The correct use of the PVC pipe production line can avoid threats to the operator's personal safety, avoid equipment problems, and make better use of the PVC pipe production line, bringing greater benefits to users.

1. When the PVC pipe production line of the factory store is assembling, debugging (matching the mold, adjusting the blade gap) or disassembling the mold, it must be carried out by personnel familiar with the machine in accordance with the prescribed procedures. The sharpness of the blade and die edge should be checked regularly. If the edge is found to be dull, it should be reground or replaced in time. Be sure to stop when changing the mold to avoid danger.

2. When the PVC pipe production line is working normally, do not put your hand or part of your body between the upper and lower molds (blade), and do not put all sundries and tools on the workbench to avoid accidents. Since the PVC pipe production line can be operated by many people, there must be a special person responsible for directing the production.

3. During operation, be careful when holding the workpiece and waiting for the slide to go down. Be sure to select the gap between the shearing blade and the die and the radius of the bending fillet according to the thickness of the copper bar (or aluminum bar).

4. Keep the oil clean and the oil circuit unblocked, and add lubricating oil to the moving parts of each unit every shift. The electrical and hydraulic components must ensure flexible movement and correct position. When abnormal phenomena are found, they must be stopped immediately for inspection.

5. In order to improve the service life of the PVC pipe production line, it is generally required to avoid direct sunlight and other thermal radiation, and avoid places that are too humid, excessive dust or corrosive gases. Corrosive gases can easily corrode and deteriorate electronic components, resulting in poor contact or short circuit between components, affecting the normal operation of the equipment. Precision PVC pipe production lines should be kept away from equipment with large vibrations, such as punching machines, forging equipment, etc.

6. In order to avoid the influence of large fluctuation of power supply (greater than ±10%) and possible instantaneous interference signals, PVC pipe production lines generally use dedicated line power supply (such as a separate channel from the low-voltage power distribution room for CNC machine tools) or add a voltage stabilizer device. etc., can reduce the influence of power supply quality and electrical interference.

7. Safety The operating procedures are one of the important measures to ensure the safe operation of the PVC pipe production line. The operator must operate according to the operating procedures. When a fault occurs, the operator should pay attention to keeping the site, and truthfully explain the situation before and after the fault to the maintenance personnel, so as to facilitate the analysis and diagnosis of the cause of the fault and eliminate it in time.

8. The PVC pipe production line should not be stored for a long time. After purchasing the PVC pipe production line, it should be fully utilized, especially after one year of use, so that the weak links that are prone to failure are exposed as soon as possible, and can be eliminated within the warranty period. When there is no processing task, the PVC pipe production line should also be energized regularly. It is best to energize 1-2 times a week, and run it for about 1 hour each time, so as to use its own heat to reduce the humidity in the machine, so that the electronic components will not be damaged. Moisture, but also can timely find out whether the battery alarm occurs, in order to prevent the loss of system software and parameters.